Welcome to another edition of I broke something, SO LETS FIX IT. While on my daily adventures I had the misfortune of my headphones falling from my head and hitting the ground, the result of thus is the controller board for the headphones became loose due to a small piece of plastic breaking free, which technically meant that the controls didn't work and charging wasn't functioning. So like any good tinkerer would do......it sat on my workbench for 3 months and then i eventually got to it during coffee time one morning this week. So the teardown was actually fairly simple, the first step was to gently pull at the edge of the earcuff where it is glued to the headphones, when you see the ring of adhesive take a flat head screw driver being careful not to tear it, and pulling up the whole ring revealing the initial 3 screw holes. ( as shown in the below picture. Screw holes are revealed after the earcuff is gently removed from headphones. First take out the three